I checked the codes again and there were 3 errors in the DME/DDE section again. I got back home and shut it down.Ībout 10 minutes later, I went out to start my car because I needed to go pick up my gf and the same error popped up but this time the engine was revving up and down on its own over and over and pressing the gas pedal did nothing at all. I did notice that the exhaust note seemed more audible in the car though. If the engine had reduced power, I wasn't really able to tell. I drove around the block and everything seemed fine. Unfortunately, the same error popped up again on the display.Īfter that, I thought well maybe the car just needs to drive around a little to relearn a value and that will fix it. I shut down the car, and started it back up to see if the problem was gone. I cleared the codes, and the light went away. Thinking that maybe I just needed to clear an error, I looked and sure enough there were two stored errors related to the DME/DDE. When I started my car back up, I got the orange half engine error on my cluster but the engine seemed to be running fine. I reset them using INPA with the engine off, ignition on. So I decided I wanted to reset all the engine adaptation values on my car to let it start fresh. OK This is going to be a long post, but I'd like to try and provide as much detail on the issue I'm having as possible from the getgo.
0 kommentar(er)
